[EN] - Configuring a Cabin in FRONT ONLY mode

The purpose of this document is to describe how to properly configure the u-Door to operate in FRONT ONLY mode (only front door can be operated)

Please note that rear doors must be maintained totally closed during inventory operations. To be sure, rear doors can be blocked in closed position.

1. From the inside of the u-Door station, tighten the rear door (white part) to the roof structure (blue part) using a M10 screw and nut.

Open

2. At application level, select "FRONT ONLY" value in Operating mode field.

3. Disconnecting the power

4. Electrical modification

• On the left top side, unscrew the 4 pan head screws and remove the housing metal cover to access to the internal electrical panel :

Open

• Make an electrical connection between "DI8" and "DI.GND" pins of ioLogik controller (Moxa) as detailed in the picture below :

5. Re-connecting the power

Front doors close automatically.

1 mn approx. after being re-connected u-Door station is ready to operate in FRONT ONLY mode.
At application level, select "FRONT ONLY" value in Operating mode field.

Related articles