| Table of Contents |
|---|
Introduction
HID’s UDor V2 Cabin is not a simple RFID reader but a station including automation (Automatic doors, door sensors, UHF field motion system, obstacle detector, push button, leds…). Front and back automatic doors enable an ergonomic operation (no pull / just push the cage).
...
There is a Connect button to initialize the connection between the software and the hardware. Then, you can start the reading process by clicking on start processing and stop it by clicking on stop processing.
Exemples of possible implementations
...
More information about the Messages Published
Upon successful connection :
...
If your host software communicates on TCP socket, the socket is only opened by standalone application only if the cabin is connected. So if it can connect it is good
if your software communicates in serial RS232 method 3.1 does not work.
in both cases you send the S character to see if the cabin responds or not (certainly with the drawback of launching a cycle for nothing)
there is no other method for querying the standalone on the condition of the cabin.
How to test and debug your Host Application if you have no UDoor
...
Abtract of UDoor User Guide (Chapter 7 concerning Standalone Application)
...